IndustryIQ - Rotary Limit Switches

Giovenzana Rotary limit switches

Typically used on cranes and other travelling machines to provide slow-down and stop limit switching in one or both directions. The series includes a variety of models with different switching characteristics. - Double-insulated enclosure in self-extinguishing material - Protected to IP65, terminals IP20 - Operating Temperature -25oC to +70oC - Cable entry: 1 x 22.5mm - Mechanical life: 1 million operations - Thermal rating 16A - Maximum operating voltage 600V - Insulation category C - Double-gap positive-break contacts with slow action

giovenzana fcr-006 2-speed slowdown and stop limit switch

giovenzana rotary limit switch catalogue FCR and FGR

giovenzana FCR006 limit switch data sheet

FCR-006 The FCR-006 is widely used in the crane industry to end-stops for long travel and cross-travel on 2-speed cranes. As the crane nears the end of the run, it hits one striker that drops it into slow speed, then hits a second that stops all travel in that direction. Simple to install and wire, the FCR- 006 is a very economical solution. The installer can replace 4 traditional limit switches, and dramatically reducing fitting time and cost. Installation in simple, with a single switch, and up to four strikers. The long arm length means that alignment is fast and easy.

Giovenzana Rotary

limit switches

Typically used on cranes and other travelling machines to provide slow-down and stop limit switching in one or both directions. The series includes a variety of models with different switching characteristics. - Double-insulated enclosure in self- extinguishing material - Protected to IP65, terminals IP20 - Operating Temperature -25oC to +70oC - Cable entry: 1 x 22.5mm - Mechanical life: 1 million operations - Thermal rating 16A - Maximum operating voltage 600V - Insulation category C - Double-gap positive-break contacts with slow action

FCR-006 The FCR-006 is widely used in the crane industry to end- stops for long travel and cross-travel on 2-speed cranes. As the crane nears the end of the run, it hits one striker that drops it into slow speed, then hits a second that stops all travel in that direction. Simple to install and wire, the FCR-006 is a very economical solution. The installer can replace 4 traditional limit switches, and dramatically reducing fitting time and cost. Installation in simple, with a single switch, and up to four strikers. The long arm length means that alignment is fast and easy.